Your water heater is one pretty used and higher priced appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving at your home heating and costs.
Regular flushing of your water heater has become single most important step you get to prolong its service life additionally, you will save energy. In a period of time, sediments amass in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. Partly destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most areas of the country, the average water heater lasts 3-5 years. Regularly flushing your water heater can double the life of your hot water heater from 3-5 to 7-10 years. Something else costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater ‘s very important in today’s affordable. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of hot water your home uses, that can mean a savings of $20 to over $50 a month.
To drain your water heater, which will help should set the thermostat to pilot (if it can be a gas water heater) or turn the circuit breaker off (if it can be an electric heater). Failure to do so could result in overheating and severe damage to the heater. Next, close the water supply valve located on a water inlet line going into your water heater. Then you’re connect a hose to the drain valve located towards the bottom of the hot water heater. Open the drain and allow it to function until all from the water has emptied from the hot water heater. Then close the drain. Open the water supply valve and refill the central heater. You should also open a hot water faucet somewhere inside the house and stand there and watch it run for several minutes until the flows out gradually. This will allow air to vent from the heater and the water lines. Finally, you can turn the thermostat to be able to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your home to filter or condition the water so is actually always less corrosive to your plumbing system, particularly in areas which have hard wetness. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in your neighborhood to discuss options and products to fit the bill.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX